How to configure PB Printer to work through USB Cable ?

How to configure PB Printer  to work through USB Cable ?

HOLD BOTH STATION1 and STATION2 BUTTONS IN THE PRINTER

Switch on the printer

Leave the Buttons

Insert the paper into the printer

Automatically Printer will take the paper inside and a message will be printed as follows

STATION 1-CONFIRM      STATION 2=SKIP    PRESS LOCAL TO CONTINUE

Press LOCAL and then STATION 1

The Default Configuration will be printed as follows

MENU          :                            CONFIG       Press STATION 1

DRAFT SPEED:               NORMAL      Press STATION 1

LQ TYPE:                        NLQ1           Press STATION 1

PAPER WIDTH:                FIRST LINE  Press STATION 1

BUZZER:                        Y                 Press STATION 1

INTERFACE                     By default SERIAL or COM1 will be there Press STATION2

Till USB is printed and then Press STATION 1

USB EMULATION            By default OLIVETTI will be there Press STATION2

                                         Till IBM is printed and then Press STATION 1

PLUG&PLAY:                             N                 Press STATION 1

PAP.EDGE DECTEC.:       N                 Press STATION 1

SPECIAL FORMS:            N                 Press STATION 1

PRINT MODE                   STANDARD  Press STATION 1

BIM MODE:                     MONO         Press STATION 1

PNS SELECTIONS:           N                 Press STATION 1

SAVE PARAMETERS        Y                 Press STATION 1

MENU          :                            CONFIG

Leave the paper in the printer and switch off the printer (Press power button in the PB printer)

SWITCH ON THE PRINTER       

Automatically the paper will be ejected

THE SAME METHOD MAY BE USED TO CONFIGURE SERIAL OR COM1 PORT

Thanks to :

P N Satish
Postmaster Grade – I
Byndoor Post Office,
Udupi Division, Karnataka - 576214